Preparation and characterization of EPDM/silica composites prepared through non-hydrolytic sol-gel method in the absence and presence of a coupling agent

Ethylene propylene diene monomer (EPDM) rubber composites containing in situ generated silica particles was prepared through a non-hydrolytic sol-gel (NHSG) method with silicon tetrachloride as precursor. The silica particles were homogenously dispersed in the EPDM matrix, but there were agglomerates at high silica contents. The swelling experi- ments showed a decrease in the crosslinking density of the vulcanized rubber due to the presence of the silica particles for both the composites prepared in the presence and absence of a coupling agent, bis-[-3-(triethoxysilyl)-propyl]-tetrasulfide (TESPT). Unlike the composites prepared through a hydrolytic sol-gel (HSG) method with TEOS as precursor, the TESPT did not seem to take part in the sol-gel reaction. The presence of TESPT influenced the interaction and dispersion of the sil- ica particles in the EPDM matrix, which gave rise to increased thermal stability of the EPDM when compared to the com- posites prepared in the absence of TESPT. However, ethylene chloride and TESPT evaporated from the samples at temperatures below the EPDM decomposition range. The values of the Nielsen model parameters, that gave rise to a good agreement with the experimentally determined Young’s modulus values, indicated improved dispersion and reduced size of the silica aggregates in the EPDM matrix. There was also good agreement between the storage modulus and Young’s mod- ulus values. The filler effectiveness (Factor C) indicated a mechanical stiffening effect and a thermal stability contribution by the filler, while the damping reduction (DR) values confirmed that the EPDM interacted strongly with the well dispersed silica particles and the polymer chain mobility was restricted. The tensile properties, however, were in some cases worse than those for the samples prepared through the HSG method in the presence of TEOS.